De bescherelle comorien
Aller à : navigation, rechercher

Lightweight framed construction is the most common construction system in michael Kors outlet Australia. At the end of construction, wood typically leaves a load of scrap and waste; 20% as compared to steel, which has about 2% waste. There was a time when the use of steel studs in residential building applications was considered exotic. Cutting or notching of studs to a depth not greater than 40 percent of the width of the stud is permitted in non-bearing partitions supporting no loads other than the weight of the partition.

Standardized and automated wall framing and workshop drawing generation enables users to jump over a few major steps in building design. Most older houses have 2-by-4 wall studs spaced 16 inches on center; many newer houses have 2-by-6 wall studs either 16 or 24 inches on center to make exterior walls stronger and create a larger cavity for wall insulation.

Light-frame structures usually gain strength from rigid panels (plywood and other plywood-like composites such as oriented strand board (OSB) used to form all or part of wall sections). Cut half-wall studs so the finished wall is slightly taller than the masonry.

But smarter materials can't achieve their potential without smart building. The Hearlihy Wood Framing Kit includes all of the materials required to construct the wood frame structure. You can then face the framing with drywall or decorative wood as shown in the opening photo.

There are a variety of wood screws made of a variety of materials. A series of long vertical posts are set 6' to 8' apart and notched to support a second-floor subfloor plate. If walls run parallel to floor joists, you'll need to nail or screw blocking in between the floor joists about every 3 ft. or so (Photo 5). For most, running in screws is easier than overhead nailing.

While wood-frame construction makes it easy for builders to construct strong, durable buildings, wall studs alone can't withstand high wind and seismic forces. A traditional wood-framed building requires a new coat of paint at least every four to seven years, with touch-ups on a regular basis.

Walls with staggered studs or double stud construction are most effective. When exceeding 4 feet (1219 mm) in height, such walls shall be framed of studs having the size required for an additional story. Over the objections of the wood products industry, the Sandy Springs City Council has approved a building code change to prohibit wood-framed construction for future buildings taller than three stories and larger than 100,000 square feet.

With balloon-frame construction, shown below, studs run full height from mud sill to the top plate, to a maximum of 20 feet. There is not a threshold beyond which a material becomes categorized as "insulation." However, both wood and steel framing will conduct heat more readily than cavity insulation products.

Conventional framing, the industry standard for framing residential construction, typically consists of 2x4 or 2x6 wood framing spaced 16 inches on center, double top plates, three-stud corners, multiple jack studs, double or triple headers, unnecessary cripple studs and other redundant members.

Wood-framed buildings require skilled laborers who must spend time cutting lumber to size, framing, and drilling holes for wiring among other things. The cost of wood stud framing from Lowe's or Home Depot will be significantly less in most cases than buying steel or SIPs.